Program *64-2 - Number Of Did/Dnis Digits For Trunk Groups - Toshiba DK14 Programming Manual

ISDN
Program *64-2 – Number of DID/DNIS Digits for Trunk Groups
Program *64-2 – Number of DID/DNIS Digits for Trunk
Groups
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Program *64-2 Overview
This program establishes the number of digits to be used for DID or DNIS table interpretation for
each ISDN trunk group.
The DK uses the last two to four digits of the incoming listed directory number (LDN) to
determine the DID call destination. If Program 17 was assigned for DNIS, the DK uses the last two
to five digits of an incoming LDN to determine the DNIS call destination.
7-26
DK40i, all RCTUs (Release 4.0 or higher) and BCUs
System, PRI and BRI
Blank
✱
SEL = 2
Enter Trunk Group Number
To add a range of trunk groups,
enter XX*XX (low trunk group *
high trunk group)
Trunk Number of DID Incoming Call
Groups Digits per Trunk Group
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
DATA = Enter the number of digits to
use for incoming call DID digits (2~5)
Strata DK Programming 5/00