Program 60-8 - Call Forward External (Remote Change, Security) Id Code - Toshiba DK14 Programming Manual

Program 60-8 – Call Forward External (Remote
Change, Security) ID Code
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Processor Type
DK14
DK40i
RCTUA
RCTUBA/BB
RCTUC/D
RCTUE/F
Telephone Port CF/EKT ID Code
Number (1~15 digits)
Program 60-8 Overview
Changes a telephone's External Call Forward destination to [PDNs] but not [PhDNs] from outside
the system. The person that wishes to change the destination must call into a DISA CO line, enter
the telephone's [PDN] +
number. CF/EXT ID code must be assigned to a telephone to allow callers to change the Call
Forward-External destination of that telephone from a remote location by calling in on a DISA CO
line.
The security code (1~15 digits) for each telephone is set with this program.
Important!
To allow Call Forward External, CO lines must be enabled for the following:
Two CO line connection in Program 10-1 and Program 15-5.
G
Outgoing Access in Program 41 including DISA port numbers.
G
Strata DK Programming 5/00
Program 60-8 – Call Forward External (Remote Change, Security) ID Code
DK14, DK40i, all RCTUs and BCUs
System
No digits
More Codes
SELECT = 8
Telephone port number to
which the CF Ext ID (security)
code will be assigned.
Port Range
000~009
000~027
000~031
000~079
000~239
000~335
Telephone Port
Number
and then enter a security code plus the destination telephone
DATA = ID code (1~15 digits)
When entering less than 15 digits, enter digits,
then press Hold.
LED Button 01 = blanks, erases data
LED Button 02 = a wild card (can be any digit
from 1~9)
Processor Type Port Range
B1CU 000~055
B2CAU/BU 000~111
B3CAU/BU 000~191
B5CAU/BU 000~335
CF/EKT ID Code Telephone Port
(1~15 digits) Number
System & Station
CF/EKT ID Code
(1~15 digits)
3-147