Program 40 - Station Co Line Access - Toshiba DK14 Programming Manual

Toll Restriction
Program 40 – Station CO Line Access
Program 40 – Station CO Line Access
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
SELECT = Station Logical Port Numbers
To add a port range, enter XXX✱XXX (low port ✱ high port).
Press to advance or
To turn all CO LEDs On or Off, after the port number and
To check a particular CO line, after the port number is entered, press
and advance.
Processor Type [PDN] Port Range
Port Number
900~916
CO Line
4-4
DK14, DK40i, all RCTUs and BCUs
Toll Restriction
All LEDs On for all CO lines (all stations can access all lines)
to go back.
DK14 000~009
DK40i 000~027
RCTUA 000~031
RCTUBA/BB 000~079
RCTUC/D 000~239
RCTUE/F 000~335
Program 16
For R4.3 and higher: If a Tie line is assigned in Program 16 for Toll Restriction and LCR
Line Group
on tandem calls, assign a class of service in this program. Program ports 900~916 to
Number
match the Tie line group numbers 01~16, respectively.
00~16
LED
20
19
18
17
16
15
14
13
12
11
10
09
08
07
06
05
04
03
02
01
LED Buttons = CO Lines
Light LEDs for the port(s) that are
allowed access.
L (all LEDs On) or
is entered, press
Vol
and enter the CO line number, then press
DISA Port
Processor Type [PDN] Port Range
(R3.X)
010 B1CU
035 B2CAU/BU
039 B3CAU/BU
089 B5CAU/BU
249
344
Port
M (all LEDs Off).
Vol
DISA Port
(R3.X)
000~055 089
000~011 249
000~191 249
000~335 344
Strata DK Programming
to display
5/00