Program 10-1 - System Assignments, Part 1 Of 3 - Toshiba DK14 Programming Manual

Program 10-1 – System Assignments, Part 1 of 3
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Button/
X
LED
Two-CO Line Conference/Allowed
20
Conference/Allowed
19
Ring Detect Time-Normal
18
Station to Station Call Volume PAD (-
17
8db)
BRI Standard Initialization (2 TEIs)
16
Not Used
15~13
12 ABR Cycles/10 times
ABR Redial time/30 sec.
11
System Speed Dial Override, Toll
10
Restriction
Exclusive Hold/Allowed
09
08 Alternate Point Answer
Ring Transfer of CO Line Allowed
07
CO Line Repeat Ringing
06
Incoming Call Abandon 8 sec.
05
CO Line DTMF Signal Time 160 msec.
04
03 Dial Pulse Make Ratio 33%
0.45 or 1.5 sec. per Program 42-0
02
Tone First (from SLTs, DKTs and EKTs)
01
Strata DK Programming 5/00
DK14, DK40i, all RCTUs and BCUs
System
LEDs 07, 08, 09, 16, 18, 19 and 20 are On
SELECT = 1 Light the LED Buttons that are marked with an X in
the table below.
LED On
Not Allowed
Two-CO line Conference must be allowed for Tandem Line, DISA,
CF-EXT, and DNIS external routing operation. Also See Program
15, Code 5.
Not Allowed
Ring Detect Time-Short Rings
No Station to Station Call PAD
None (TEI = 0)
Not Used
15 times
1 min.
Restricted
Not Allowed
Transfer Privacy
Not Allowed
If Ring Transfer is allowed, set Ring Transfer Recall time in Program
37; if ring transfer is not allowed (LED 07 Off), the station recalls
immediately if transfer is attempted.
Standard Ring
Standard ring pattern is 1 sec. on, 3 sec. off.
6 sec.
80 msec.
LED 04 DTMF Signal Time applies to manual and speed dial tones
sent out of the system via CO lines. This applies when dialing from
any Toshiba telephone, including the 2000-series Digital Telephone.
LED 04 does not apply to Call Forward or Voice Mail ID DTMF tones
sent to voice mail ports. (See Program 10-2, LED 06, for tones sent
to Voice Mail ports.)
40%
CO Line Re-seize guard time 0.45
CO line guard time is the time interval the system requires to release
a CO line and reseize it. If LED 02 is off, all lines are set with 0.45
second guard time; if LED is on, guard time is 0.45 or 1.5 seconds
per Program 42-0.
Voice First (from SLTs, DKTs and EKTs)
This applies to [PDNs] not [PhDNs]; [PhDNs] are always tone first.
System & Station
Program 10-1 – System Assignments, Part 1 of 3
LED Off
3-27