Toshiba DK14 Programming Manual page 122

System & Station
Program 30 – Station Class of Service
LED 15: Change Verified Account Code
With LED 15 On, a station can change the Verified Account Codes established in Program 69.
Selected stations must dial the following sequence to change the codes:
[PDN] +
Press button if your electronic telephone does not have a
length is set in Program 10-4 (up to 15 digits). All digits do not have to be verified.
LED 14: Verified Account Code
With LED 14 On, the system verifies all Forced or Voluntary Account Codes (set in Program 69)
dialed by the station user. If the station user does not dial a specific Verified Account Codes, the
call does not execute (Forced), or the Account Code is not validated for the SMDR call report
(Voluntary).
To force a verified account code entry on Two-CO line DISA calls through the system, turn LED
08 and 14 On for Port 10-DK14, Port 035-DK40i, Port 039-RCTUA, Port 089-RCTUB,
RCTUBA/BB or Port 249-RCTUC/D or Port 344-RCTUE/F. Also, you must enable Forced
Account Code for outgoing CO line in Program 15-7.
LED 12: Single Line Telephone (SLT) Hookflash Anti-bounce Guard
SLT Hookflash Anti-Bounce Guard (LED 12 On) prevents false recalls due to hook flash bounce
during SLT hang-up on outside calls. The system automatically disconnects the CO line if the SLT
hangs-up after a Hook Flash.
Use for QSTU2, PSTU, RSTU, RSTU2, RDSU, PESU, and KSTU2 standard telephone ports that
have standard telephones (with/without message lamps) connected to them to prevent false ring
signals. With this option On, a CO line connected to a standard telephone is disconnected if the
standard telephone user hookflashes and then hangs up. If this option is Off, the CO line recalls the
standard telephone.
LED 11: Dial Pulse - Dual-tone Multi-frequency (DTMF) Off
Use Dial Pulse - DTMF Off (LED 11 On) if any device, DID or Tie line station port does not
require the RRCS, BRCS, K5RCU, K5RCU2, or K4RCU for DTMF decoding. When the device
goes off-hook or the DID or Tie line is seized for an incoming call, the DTMF receiver is not
accessed - reducing unnecessary traffic to it.
If a Tie or DID line is Dial Pulse (Program 15-1, LED On), enable Dial Pulse - DTMF Off (LED
11 On) for that Tie or DID station port number. If the DID or Tie line is DTMF tone dial (Program
15-1, LED Off) disable Dial Pulse - DTMF Off (LED 11 Off) and install an RRCS, the RCTU,
K5RCU, K5RCU2, K4RCU3 in the DK40i, or BRCS on B1CU, B2CAU/BU,
B3CAU/BU and B5CAU/BU.
LED 10: Change DISA Security Code
When enabled (LED 10 On), allows a selected station to change the DISA security code by dialing
[PDN] +
3-78
+ Verified Account Code +
System
RCTUE/F, B5CAU/BU
RCTUA, BA/BB, C/D, B1CU/BU, B2CAU/BU,
B3CAU/BU, B3BAU/BU, DK40i, DK14
, + Security Code +
:
Redial
Verified Account Code
000~499
000~299
button.Total Account Code digit
.
Strata DK Programming 5/00