Toshiba DK14 Programming Manual page 33

Program 90 Example
1. Use the LCD programming phone per Minimum Hardware
Requirements on Page
Enter Program mode by pressing ✱ ✱
2.
button.)
3.
Access Program 90. System beeps after
to indicate program number may be entered.
4.
Prepare the system for the programs to be initialized.
✱✱
5. + LED buttons 01 & 02
Enter Program numbers individually, followed by #, or in a range. For a
range, separate the low program number and the high program
number with an asterisk.
✱✱
initializes all Programs 00~ 99.
Star ✱ Program memory follows Program 97.
6.
Secure data in system programming. LEDs 01 and 02 flash.
7.
Prepare system for another selection (go back to Step 5) or exit
Program 90 (continue with Step 8).
8.
Secure default data in system memory. LED 01 and 02 continue to
flash.
9.
Exit Program 90. Enter another program number (see
Example" on Page 2-10) or exit programming mode (go to Step 10).
System beeps to indicate it is exiting Program 90.
10.
Exit programming mode.
The system will not allow the
enter the programming mode.
1. N-N is the Program Telephone [DN].
Strata DK Programming 5/00
Action
1-14.
✱ ✱ . (Do not press [DN]
LED to light to re-
Program 90 – Initialize Programs 00~*99
Jan 20 Sun
Program Mode
Program = 90
is pressed
90 Select =
90 Select = 00**99
Data Clr
90 Select = 00**99
Data Programmed
90 Select =
90 Select = ##
Data Programmed
Program =
"Program 92
Jan 20 Sun
Initialization & Test
LCD Response
1
No. N-N
06:43
Data Store
No. N-N
06:43
2-5