Toshiba DK14 Programming Manual page 204

System & Station
Program 72 – DNIS Number Network Table Assignments
Program 72 Overview
This program defines the external Network routing numbers that can be assigned DNIS/Tie/DID
extension numbers in the Day, Day2, or Night ringing mode. This assignment will cause incoming
DNIS/Tie/DID calls to route (forward) back out over a public, or private, telephone network to a
pre-assigned telephone number.
To assign a Tie/DID line to Program 72 assignments: The DNIS/Tie/DID extension number must
be assigned to route to the appropriate Network routing number in Program 71-1.
This program can also be used with non-DNIS or ANI (only), Tie and/or DID Lines to assign
normal incoming Tie/DID calls to route back out over the public, or private telephone network to
an external telephone number.
Important!
Tie/DID lines used for DNIS network routing must be enabled with tandem (Two-CO line)
G
connection with Program 15, Code 5 and Program 10-1, LED 20.
DNIS Network routing numbers will not be restricted by DK424 Toll Restriction assignments.
G
Tie/DID lines must have LED 05 On in Program 17 to use the (DID, Tie) DNIS routing
G
assignments in Program 71 and 72.
DNIS network calls are timed by the Program 12 disconnect timer which, if set to default, will
G
disconnect the call after four minutes. The disconnect timer may be disabled
(see
3-160
"Program 12 – System Assignments, Basic Timing" on Page 3-44).
Strata DK Programming 5/00