Trunk Programs Overview - Toshiba DK14 Programming Manual

Trunk Programs Overview

See Flowchart 7-2
o If you are installing all standard trunk groups, skip Program *16 (the default is for all standard
TGs).
o If you are installing BRI ISDN, use Program *16 to assign BRI type and Program 16 to assign
BRI CO lines into trunk groups.
o If you are installing PRI, use Program *16 to assign PRI types. Do not use Program 16. Do not
change settings in Program 16 for trunk groups marked for PRI.
Primary Rate Interface (PRI) Programming
1. Run Program *16 to define the ISDN trunk group type as: non-ISDN, Primary Rate Interface
(PRI), or Basic Rate Interface (BRI).
2. For BRI trunk groups, run Program 16 to assign the trunk groups. Then, skip to
3. For PRI, run Program *65 to assign B-channels.
4. For PRI, run Programs *66-1, *66-3 to define trunk groups parameters and channels. (Program
16 will be assigned automatically.)
5. To assign Call-by-call features (PRI only), run Programs *66-2, *66-4, *67-3, *67-4, *67-5 to
assign Call-by-Call trunk groups codes and network ID.
6. For PRI, run Program *67 to assign call direction for ISDN trunk groups and call type
capabilities allowed for each trunk group.
7. For BRI and PRI, run Program *68 to define the parameters for Calling Number to be
presented for a call depending upon whether the ISDN trunk group uses DID, private numbers
or use default number programmed in *68-2.
8. For BRI and PRI, run Program *66-5 to assign Listed Directory Numbers (LDNs) to channel
groups and index numbers. Next, run Program *66-6 to assign LDN channel groups to ISDN
trunk ports. Then run Program *66-7 to assign trunk groups to each LDN.
9. Run Program *68-2 to define whether or not the system presents a "user" Caller ID when calls
are made using ISDN services. This program also enables users to dial a code to send Caller
ID or to block it.
10. For BRI and PRI, run Program *69 to define the parameters for Calling Number to be
presented. Each phone can present a unique Caller ID number, such as DID or a private
number. If neither is chosen, the default is the Directory Number entered in Program *68-2 for
outgoing calls.
11. Run Program *64 to assign each ISDN trunk group to use DID/DNIS programming, or to
provide Direct in Line (DIL) ringing for incoming calls.
12. See "ISDN Related Programs" on Page
assignments.
Strata DK Programming 5/00
for an overview of the ISDN trunk programming procedure.
7-3, and make the appropriate programming
ISDN
Trunk Programs Overview
Step 7.
7-5