Toshiba DK14 Programming Manual page 55

Program 03 Example
Action (press buttons + LED buttons)
1. Use an LCD programming phone per Minimum Hardware
Requirements on Page 1-14.
✱ ✱ ✱ ✱
2.
Enter programming mode. (Do not press [DN] button.)
3.
Access Program 03. System beeps after
to indicate program number may be entered.
4.
Prepare the system for a selection.
5. Dial a PCB slot number (00~78 for DK424 or 00-18 for DK40i) using
the dial pad.
The system defaults as follows:
Initialized default assigns slot 00 and 01 to be a non-optioned RCTU
without RRCS DTMF receivers, or DK40i Base without K4RCU3,
K5RCU, and K5RCU2.
Initialized default assigns slot 11 to be a non-optioned PDKU without
DSS console or OCA (Code 61).
(DK424),
Initialized default assigns slot 12~78 to be empty (Code 00).
6.
Dial the PCB code recorded on the record sheet. Refer to the PCB
code reference table on Program 03 record sheet for a definition of the
codes.
7.
Secure data in system programming.
8.
Prepare system for another selection (go back to Step 5) or continue
with Step 9.
9.
Secure Program 92 data in system memory.
10.
Exit Program 92 (system beeps). Enter another program number or
exit programming mode (go to Step 11).
11.
Exit programming mode.
12. To secure Program 03 entries, Power off for five seconds, then power
on, or run Program 91-2.
Strata DK Programming 5/00
Program 03 for DK424i – Flexible PCB Cabinet Slot Assignments
is pressed
(DK40i)
System & Station
LCD Response
No. 205
Jan 20 Sun
Program Mode
Program = 03
Data Store
03 Select =
03 Select = (00~78)
Card = (91, 62 or 00)
03 Select = 00 (Slot Number)
Card = 91
03 Select = 11 (Slot Number)
Card = 61
03 Select = 12~78 (Slot
Number)
Card = 00
03 Select = (00~78)
Card = (00~97)
03 Select = (00~78)
Data Programmed
03 Select =
92 Select = ##
Data Programmed
Program =
No. 205
Jan 20 Sun
06:43
06:58
3-11