Dell Force10 Z9000 Configuration Manual page 538

Report interval frequency and mode adjustments can be made by supplementing this command as well.
Step Task
1 Setup two or more connected
interfaces for Layer 2 or Layer 3 use
2 Activate the necessary ports
administratively
3 Enable fefd globally
Entering the
interface.
Figure 24-11. Show FEFD global outputs
FTOS#show fefd
FEFD is globally 'ON', interval is 3 seconds, mode is 'Normal'.
INTERFACE
Gi 1/0
Gi 1/1
Gi 1/2
Gi 1/3
FTOS#show run fefd
!
fefd-global mode normal
fefd-global interval 3
Enable FEFD on an Interface
Entering the command
FEFD mode, supplement the
aggressive
{
To disable FEFD protocol on one interface, enter the command
Disabling an interface will shut down all protocols working on that interface's connected line, and will not
delete your previous FEFD configuration which can be enabled again at any time.
Step Task
1 Setup two or more connected
interfaces for Layer 2 or Layer 3 use
2 Activate the necessary ports
administratively
| Layer 2
538
show fefd
command in EXEC privilege mode displays information about the state of each
MODE INTERVAL
(second)
Normal 3
Normal 3
Normal 3
Normal 3
fefd
in INTERFACE mode enables FEFD on a per interface basis. To change the
fefd
command in INTERFACE mode by entering the command
normal
| }].
Command Syntax Command Mode
ip address ip
INTERFACE
address,
switchport
no shutdown
INTERFACE
fefd {interval |
CONFIGURATION
mode}
STATE
Bi-directional
Admin Shutdown
Admin Shutdown
Admin Shutdown
Command Syntax Command Mode
ip address ip
INTERFACE
address,
switchport
no shutdown
INTERFACE
fefd disable
in INTERFACE mode.
fefd mode
[