Dell Force10 Z9000 Configuration Manual page 54

Create a Custom Privilege Level
FTOS(conf)#do show run priv
!
privilege exec level 3 capture
privilege exec level 3 configure
privilege exec level 4 resequence
privilege exec level 3 capture bgp-pdu
privilege exec level 3 capture bgp-pdu max-buffer-size
privilege configure level 3 line
privilege configure level 3 interface
FTOS(conf)#do telnet 10.11.80.201
[telnet output omitted]
FTOS#show priv
Current privilege level is 3.
FTOS#?
capture
configure
disable
enable
exit
ip
monitor
mtrace
ping
quit
show
[output omitted]
FTOS#config
[output omitted]
FTOS(conf)#do show priv
Current privilege level is 3.
FTOS(conf)#?
end
exit
interface
line
linecard
FTOS(conf)#interface ?
fastethernet
gigabitethernet
loopback
managementethernet
null
port-channel
range
sonet
tengigabitethernet
vlan
FTOS(conf)#interface gigabitethernet 1/1
FTOS(conf-if-gi-1/1)#?
end
exit
FTOS(conf-if-gi-1/1)#exit
FTOS(conf)#line ?
aux
console
vty
FTOS(conf)#line vty 0
FTOS(config-line-vty)#?
exit
FTOS(config-line-vty)#
| Management
54
Capture packet
Configuring from terminal
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Global IP subcommands
Monitoring feature
Trace reverse multicast path from destination to source
Send echo messages
Exit from the EXEC
Show running system information
Exit from configuration mode
Exit from configuration mode
Select an interface to configure
Configure a terminal line
Set line card type
Fast Ethernet interface
Gigabit Ethernet interface
Loopback interface
Management Ethernet interface
Null interface
Port-channel interface
Configure interface range
SONET interface
TenGigabit Ethernet interface
VLAN interface
Exit from configuration mode
Exit from interface configuration mode
Auxiliary line
Primary terminal line
Virtual terminal
Exit from line configuration mode