Table 23-3. Correct Value Range for the isis metric command
Metric Style
narrow transition
transition
Configuring the distance of a route
Configure the distance for a route using the
Change the IS-type
You can configure the system to act as one of the following:
•
Level 1 router
•
Level 1-2 router
•
Level 2 router
Use the following command in ROUTER ISIS mode to change the IS-type for the router, u
Command Syntax
is-type {level-1 | level-1-2 | level-2-only}
Command Syntax
is-type {level-1 | level-1-2 | level-2}
Use the
show isis protocol
configured. The
show config
if you do not change the IS-type, the default value (level-1-2) is not displayed.
The default is Level 1-2 router. When the IS-type is Level 1-2, the software maintains two Link State
databases, one for each level. Use the
(Figure
477).
Correct Value Range
0 to 63
0 to 63
distance
Command Mode
ROUTER ISIS
Command Mode
ROUTER ISIS
command in EXEC Privilege mode
command in ROUTER ISIS mode displays only non-default information, so
show isis database
command from ROUTER ISIS mode.
Purpose
Configure IS-IS operating level for a router.
Default is level-1-2.
Purpose
Change the IS-type for the IS-IS process.
(Figure 476)
command to view the Link State databases
Intermediate System to Intermediate System | 503
to view which IS-type is