Bulk Configuration; Interface Range; Bulk Configuration Examples - Dell Force10 Z9000 Configuration Manual

Ftos configuration guide for z9000 system

Hide thumbs Also See for Force10 Z9000:

Table of Contents

For more on load-balancing, see "Equal Cost Multipath and Link Aggregation Frequently Asked

Questions" in the E-Series FAQ section (login required) of iSupport:

https://www.force10networks.com/CSPortal20/KnowledgeBase/ToolTips.aspx

Bulk Configuration

Bulk configuration enables you to determine if interfaces are present, for physical interfaces, or,

configured, for logical interfaces.

An interface range is a set of interfaces to which other commands may be applied, and may be created if

there is at least one valid interface within the range. Bulk configuration excludes from configuration any

non-existing interfaces from an interface range. A default VLAN may be configured only if the interface

range being configured consists of only VLAN ports.

interface range

applied to that range of interfaces.

The interface range prompt offers the interface (with slot and port information) for valid interfaces. The

maximum size of an interface range prompt is 32. If the prompt size exceeds this maximum, it displays (...)

at the end of the output.

Note: Non-existing interfaces are excluded from interface range prompt. In the following example,

Tengigabit 3/0 and VLAN 1000 do not exist.

Note: When creating an interface range, interfaces appear in the order they were entered and are not

all interfaces that have been validated under the interface range context.

show configuration

you to display the running configuration only for interfaces that are part of interface range.

The following are examples of using the

Create a single-range

Create a multiple-range

Exclude duplicate entries

Exclude a smaller port range

command allows you to create an interface range allowing other commands to be

command is available under interface range mode. This command allows you to display

command is also available under the interface range mode. This command allows

interface range

command for bulk configuration:

Table of Contents