Protocol Lldp - Dell Force10 Z9000 Configuration Manual

If LLDP is configured both globally and at interface level, the interface level configuration overrides the
global configuration. To advertise TLVs:
Step Task
1 Enter LLDP mode.
2 Advertise one or more TLVs. Include the keyword for
each TLV you want to advertise.
For management TLVs: system-capabilities,
•
system-description
For 802.1 TLVs: port-protocol-vlan-id,
•
port-vlan-id, vlan-name
For 802.3 TLVs: max-frame-size
•
• For TIA-1057 TLVs:
•guest-voice
•guest-voice-signaling
•location-identification
•power-via-mdi
•softphone-voice
•streaming-video
•video-conferencing
•video-signaling
•voice
•voice-signaling
Note: vlan-name is supported on C-Series and S-Series only.
In Figure 25-8, LLDP is enabled globally. R1 and R2 are transmitting periodic LLDPDUs that contain
management, 802.1, and 802.3 TLVs.
Figure 25-8. Configuring LLDP
R2(conf)#protocol lldp
R2(conf-lldp)#no disable
R2(conf-lldp)#advertise management-tlv system-capabilities system-description
R2(conf-lldp)#ad dot1-tlv vlan-name
R2(conf-lldp)#max-frame-size
R2
R2(conf)#int gig 2/11
R2(conf-if-gi-2/11)# switchport
R2(conf-if-gi-2/11)#no shut
R1(conf)#int gig 1/21
R1(conf-if-gi-1/21)# switchport
R1(conf-if-gi-1/21)#no shut
Command

protocol lldp

advertise {management-tlv |
dot1-tlv | dot3-tlv | med}
R1(conf)#protocol lldp
R1(conf-lldp)#no disable
R1(conf-lldp)#advertise management-tlv system-capabilities system-description
R1(conf-lldp)#ad dot1-tlv vlan-name
R1(conf-lldp)#max-frame-size
R1
1/21
2/11
LLDPDU
Command
Mode
CONFIGURATI
ON or
INTERFACE
PROTOCOL
LLDP
fnC0074mp
Link Layer Discovery Protocol (LLDP) | 551