Dell Force10 Z9000 Configuration Manual page 955

Step Task
2 Configure virtual IP addresses
for this VRID.
Figure 49-4. Command Example: virtual-address
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.1
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.2
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.3
FTOS(conf-if-gi-1/1-vrid-111)#
Figure 49-5. Command Example Display: show config for the Interface
FTOS(conf-if-gi-1/1)#show conf
!
interface GigabitEthernet 1/1
ip address 10.10.10.1/24
!
vrrp-group 111
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
!
vrrp-group 222
no shutdown
FTOS(conf-if-gi-1/1)#
Figure 49-6 shows the same VRRP group configured on multiple interfaces on different subnets.
Command Syntax
virtual-address ip-address1 [...ip-address12]
Range: up to 12 addresses
Note that the Primary IP address
and the Virtual IP addresses are
on the same subnet
Command Mode
INTERFACE -VRID
Virtual Router Redundancy Protocol (VRRP) | 955