Dell Force10 Z9000 Configuration Manual page 634

Use these commands on one of the interfaces to enable OSPFv2 routing.
Step Command Syntax
1 ip address
2 no shutdown
Return to CONFIGURATION mode to enable the OSPF process. The OSPF Process ID is the identifying
number assigned to the OSPF process, and the Router ID is the IP address associated with the OSPF
process.
Command Syntax
router ospf process-id
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the
system.
If you try to enter an OSPF Process ID, or if you try to enable more OSPF processes than available Layer 3
interfaces, prior to assigning an IP address to an interface and setting the no shutdown command, you will
see the following message.
Message 1
C300(conf)#router ospf 1
% Error: No router ID available.
In CONFIGURATION ROUTER OSPF mode, assign the Router ID. The Router ID is not required to be
the router's IP address. Dell Force10 recommends using the IP address as the Router ID for easier
management and troubleshooting:
Command Syntax
router-id ip address
Use the
no router ospf
Use the
clear ip ospf
| Open Shortest Path First (OSPFv2 and OSPFv3)
634
ip-address mask
Command Mode
[ { }]
vrf vrf name CONFIGURATION
command syntax in the CONFIGURATION mode to disable OSPF.
process-id
command syntax in EXEC Privilege mode to reset the OSPFv2 process.
process-id
Command Mode
CONFIG-INTERFACE
If using a Loopback interface, refer to
CONFIG-INTERFACE
Usage
Enable the OSPFv2 process globally.
Range: 0-65535
vrf name: (
available on E-Series only.
keyword and instance name to tie the OSPF instance to
the VRF. All network commands under this OSPF
instance are subsequently tied to the VRF instance.
Command Mode
CONFIG-ROUTER-O
SPF-id
Usage
Assign an IP address to an interface.
Format: A.B.C.D/M
Loopback Interfaces.
Enable the interface.
) Enter the VRF
Usage
Assign the Router ID for the OSPFv2
process.
IP Address: A.B.C.D