Command Output - Dell Force10 Z9000 Configuration Manual

Figure 21-8. Command Example: show
FTOS#show ipv6 route
Codes: C - connected, L - local, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
Gateway of last resort is not set
Destination Dist/Metric,
-----------------------------------------------------
C 600::/64 [0/0]
Direct, Te 0/24, 00:34:42
C 601::/64 [0/0]
Direct, Te 0/24, 00:34:18
C 912::/64 [0/0]
Direct, Lo 2, 00:02:33
O IA 999::1/128 [110/2]
via fe80::201:e8ff:fe8b:3166, Te 0/24, 00:01:30
L fe80::/10 [0/0]
Direct, Nu 0, 00:34:42
FTOS#
Figure 21-9 illustrates the
Figure 21-9. Command Example:
FTOS#show ipv6 route summary
Route Source
connected
static
Total
Figure 21-10 illustrates the
Figure 21-10. Command Example:
FTOS#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
S 9999:9999:9999:9999::/64 [1/0]
ipv6 route
Gateway,
show ipv6 route summary
show ipv6 route summary
Active Routes Non-active Routes
5 0
0 0
5 0

command output.

show ipv6 route static
show ipv6 route static
via 2222:2222:3333:3333::1, Gi 9/1, 00:03:16
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
Last Change
command output.
IPv6 Routing | 465