Management Interfaces; Configure Management Interfaces On The E-Series, C-Series, S4810 And Z9000 - Dell Force10 Z9000 Configuration Manual

Command Syntax
ip address ip-address mask [secondary]
You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the
EXEC mode.
To view IP information on an interface in Layer 3 mode, use the
Privilege mode.
Figure 19-7. Command Example: show ip interface
FTOS>show ip int vlan 58
Vlan 58 is up, line protocol is up
Internet address is 1.1.49.1/24
Broadcast address is 1.1.49.255
Address determined by config file
MTU is 1554 bytes
Inbound
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent

Management Interfaces

The S4810 and Z9000 systems support the Management Ethernet interface as well as the standard S-Series
interface on any port. Either method can be used to connect to the system.
Configure Management Interfaces on the E-Series, C-Series,
S4810 and Z9000
On the E-Series, C-Series, S4810 and Z9000, the dedicated Management interface provides management
access to the system. You can configure this interface with FTOS, but the configuration options on this
interface are limited. Gateway addresses and IP addresses cannot be configured if it appears in the main
routing table of FTOS. In addition, Proxy ARP is not supported on this interface.
| Interfaces
380
access list is not set
Command Mode Purpose
INTERFACE Configure a primary IP address and mask on
the interface. The ip-address must be in
dotted-decimal format (A.B.C.D) and the
mask must be in slash format (/xx).
Add the keyword secondary if the IP address
is the interface's backup IP address.
show ip interfaces brief
show ip interface
command in the
command in the EXEC