Dell Force10 Z9000 Configuration Manual page 350

Step Command Syntax
interface primary int
3
slot/port secondary int
slot/port control-vlan
vlan id
mode transit
4
member-vlan vlan-id
5
{range}
no disable
6
Set FRRP Timers
Step Command Syntax
timer
1
{hello-interval|dead-interval}
milliseconds
| Force10 Resilient Ring Protocol (FRRP)
350
Command Mode
CONFIG-FRRP
CONFIG-FRRP
CONFIG-FRRP
CONFIG-FRRP
Command Mode
CONFIG-FRRP
The Dead-Interval time should be set at 3x the Hello-Interval.
Purpose
Assign the Primary and Secondary ports, and the
Control VLAN for the ports on the ring.
Interface:
• For a 10/100/1000 Ethernet interface, enter the
GigabitEthernet
keyword keyword
the slot/port information.
• For a Gigabit Ethernet interface, enter the
GigabitEthernet
keyword
port information
• For a SONET interface, enter the keyword
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
TenGigabitEthernet
keyword
slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Slot/Port: Slot and Port ID for the interface.
VLAN ID: Identification number of the Control
VLAN
Configure a Transit node
Identify the Member VLANs for this FRRP group
VLAN-ID, Range: VLAN IDs for the ring's Member
VLANs.
Enable this FRRP group on this switch.
Purpose
Enter the desired intervals for Hello-Interval or
Dead-Interval times.
Hello-Interval: 50-2000, in increments of 50
(default is 500)
Dead-Interval: 50-6000, in increments of 50
(default is 1500)
followed by
followed by the slot/
sonet
followed by the