Configure Login Authentication For Terminal Lines - Dell Force10 Z9000 Configuration Manual

To apply an IP ACL to a line:
Task
Apply an ACL to a VTY line.
To view the configuration, enter the
Access List to a VTY
Applying an Access List to a VTY Line
FTOS(config-std-nacl)#show config
!
ip access-list standard myvtyacl
seq 5 permit host 10.11.0.1
FTOS(config-std-nacl)#line vty 0
FTOS(config-line-vty)#show config
line vty 0
access-class myvtyacl
FTOS Behavior: Prior to FTOS version 7.4.2.0, in order to deny access on a VTY line, you must apply
an ACL and AAA authentication to the line. Then users are denied access only after they enter a
username and password. Beginning in FTOS version 7.4.2.0, only an ACL is required, and users are
denied access before they are prompted for a username and password.

Configure Login Authentication for Terminal Lines

You can use any combination of up to 6 authentication methods to authenticate a user on a terminal line. A
combination of authentication methods is called a method list. If the user fails the first authentication
method, FTOS prompts the next method until all methods are exhausted, at which point the connection is
terminated. The available authentication methods are:
enable
• —Prompt for the enable password.
line
• —Prompt for the e password you assigned to the terminal line. You must configure a password for
the terminal line to which you assign a method list that contains the
Configure a password using the command password from LINE mode.
local
• —Prompt for the system username and password.
none
• —Do not authenticate the user.
radius
• —Prompt for a username and password and use a RADIUS server to authenticate.
tacacs+
• —Prompt for a username and password and use a TACACS+ server to authenticate.
Command Syntax
ip access-class access-list
show config
Line.
Command Mode
LINE
command in the LINE mode, as shown in
line
Applying an
authentication method.
Management | 65