Dell Force10 Z9000 Configuration Manual page 671

Use the following command in EXEC Privilege mode to configure the debugging options of an OSPFv3
process:
Command Syntax
[ |
debug ipv6 ospf event packet
{ type slot / port }
Command Mode
] EXEC Privilege
Usage
View debug messages for all OSPFv3 interfaces.
• : View OSPF event messages.
event
• : View OSPF packets.
packet
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(e.g., passive-interface gi 2/1).
• For a port channel, enter the keyword
followed by a number from 1 to 255 for TeraScale and
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information
TenGigabitEthernet
(e.g., passive-interface ten 2/3).
• For a VLAN, enter the keyword
number from 1 to 4094 (e.g., passive-interface
vlan 2222).
FTOS supports 4094 VLANs.
Open Shortest Path First (OSPFv2 and OSPFv3) | 671
port-channel
followed by a
vlan