Dell Force10 Z9000 Configuration Manual page 760

Figure 36-14. Using show ip routes for Core 3 RIP Setup
Core3#show ip routes
Codes: C - connected, S - static, R - RIP,
Gateway of last resort is not set
R
C
C
R
R
C
C
Core3#
Figure 36-15. Using show ip protocols Command to Show RIP Configuration Activity on Core 3
Core3#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 6
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is
Default version control: receive version 2, send version 2
Routing for Networks:
Routing Information Sources:
Gateway
10.11.20.2
Distance: (default is 120)
Core3#
| Routing Information Protocol (RIP)
760
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Destination Gateway
----------- -------
10.11.10.0/24 via 10.11.20.2, Gi 3/21
10.11.20.0/24 Direct, Gi 3/21
10.11.30.0/24 Direct, Gi 3/11
10.200.10.0/24 via 10.11.20.2, Gi 3/21
10.300.10.0/24 via 10.11.20.2, Gi 3/21
192.168.1.0/24 Direct, Gi 3/43
192.168.2.0/24 Direct, Gi 3/44
Interface Recv
GigabitEthernet 3/21
GigabitEthernet 3/11
GigabitEthernet 3/44
GigabitEthernet 3/43
10.11.20.0
10.11.30.0
192.168.2.0
192.168.1.0
Distance
120
1
Send
2 2
2 2
2 2
2 2
Last Update
00:00:22
Dist/Metric Last Change
----------- -----------
120/1 00:01:14
0/0 00:01:53
0/0 00:06:00
120/1 00:01:14
120/1 00:01:14
0/0 00:06:53
0/0 00:06:26