Dell Force10 Z9000 Configuration Manual page 502

Figure 23-7. Command Example:
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: EEEE.EEEE.EEEE
Manual area address(es):
47.0004.004d.0001
Routing for area address(es):
21.2223.2425.2627.2829.3031.3233
47.0004.004d.0001
Interfaces supported by IS-IS:
Vlan 2
GigabitEthernet 4/22
Loopback 0
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics:
Generate wide metrics:
Accept wide metrics:
FTOS#
When you change from one IS-IS metric style to another, the IS-IS metric value could be affected. For each
interface with IS-IS enabled, you can assign a cost or metric that is used in the link state calculation.
Use the following command in INTERFACE mode to change the metric or cost of the interface.
Command Syntax
isis metric default-metric [level-1 |
level-2]
isis ipv6 metric default-metric [level-1 |
level-2]
Use the
show config
Privilege mode to view the interface's current metric.
Table 23-3. Correct Value Range for the isis metric command
Metric Style
wide
narrow
wide transition
| Intermediate System to Intermediate System
502
show isis protocol
IS-Type: level-1-2
level-1-2
none
none
Command Mode
INTERFACE
INTERFACE
command in INTERFACE mode or the
Correct Value Range
0 to 16777215
0 to 63
0 to 16777215
IS-IS metrics settings
Purpose
default-value range: 0 to 63 if the metric-style is
narrow, narrow-transition or transition. 0 to 16777215
if the metric style is wide or wide transition.
Default: 10.
Assign a metric for an IPv6 link or interface.
• range: 0 to 63 for narrow and
default-metric
transition metric styles; 0 to 16777215 for wide
metric styles.
Default is 10.
Default level is level-1.
Refer to Configure IS-IS metric style and cost
information on this command.
show isis interface
for more
command in EXEC