To test the condition of cables on 10/100/1000 BASE-T modules, use the
Step
Command Syntax
tdr-cable-test gigabitethernet <slot>/
1
<port>
show tdr gigabitethernet <slot>/
2
<port>
Splitting QSFP ports to SFP+ ports
Splitting QSFP ports to SFP+ ports
The Z9000 supports splitting a single 40G QSFP port into four 10G SFP+ ports using one of the supported
breakout cables (refer to the Z9000 Installation Guide or the Z9000 Release Notes for a list of supported
cables).
Command Syntax
stack-unit stack-unit port
number portmode quad
Command Mode
EXEC Privilege
EXEC Privilege
is supported on platform
Command Mode
Purpose
CONFIGURATION
Split a single 40G port into 4-10G ports on the Z9000.
stack-unit:
member to reset.
Z9000 range: 0 - 11
number:
Range: 0-31
tdr-cable-test
Usage
To test for cable faults on the GigabitEthernet
cable.
•
Between two ports, the user must not start
the test on both ends of the cable.
•
The user must enable the interface before
starting the test.
•
The port should be enabled to run the test
or the test prints an error message.
Displays TDR test results.
z
Enter the stack member unit identifier of the stack
Enter the port number of the 40G port to be split.
command:
Interfaces | 403