View Advanced Interface Information; Display Only Configured Interfaces - Dell Force10 Z9000 Configuration Manual

Figure 19-34. Setting Auto-Negotiation Options
FTOS(conf)# int gi 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end
exit
mode
no
show
FTOS(conf-if-autoneg)#mode ?
forced-master
forced-slave
FTOS(conf-if-autoneg)#
For details on the
Command Reference Guide
Adjust the keepalive timer
Use the
keepalive
The interface sends keepalive messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command:
Command Syntax
keepalive [seconds]
To view the new setting, use the

View Advanced Interface Information

Display Only Configured Interfaces

The following options have been implemented for
linecard interfaces. When the
configurations are displayed. Dummy linecard interfaces (created with the
like any other physical interface.
Figure 19-35 lists the possible show commands that have the configured keyword available:
Exit from configuration mode
Exit from autoneg configuration mode
Specify autoneg mode
Negate a command or set its defaults
Show autoneg configuration information
Force port to master mode
Force port to slave mode
speed duplex negotiation auto
, , and
.
command to change the time interval between keepalive messages on the interfaces.
Command Mode
INTERFACE
show config
configured
keyword is used, only interfaces that have non-default
commands, see the Interfaces chapter of the
Purpose
Change the default interval between keepalive
messages.
command in the INTERFACE mode.
show [ip | running-config] interfaces
FTOS
commands for (only)
linecard
command) are treated
Interfaces | 415