Dell Force10 Z9000 Configuration Manual page 250

Reload without a DHCP Server Offer
A switch configured to reload in BMP mode and if the DHCP server cannot be reached, the system keeps
on sending DISCOVER messages.
00:01:44: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DISCOVER: DHCP DISCOVER sent on Te 0/50.
00:01:44: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DISCOVER: DHCP DISCOVER sent on Te 0/51.
00:01:44: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DISCOVER: DHCP DISCOVER sent on Ma 0/0.
Reload with a DHCP Server Offer without an FTOS Image
If a switch that is configured to reload in BMP mode reaches a DHCP server but does not locate a
downloadable FTOS image file on the server, it attempts to download the configuration file.
1. The system boots up with the BMP application.
13:23:47: %STKUNIT0-M:CP %JUMPSTART-5-BOOT_OFFER: DHCP acquired IP 10.16.134.167 mask 255.255.0.0 server
IP 10.16.134.207.
13:23:48: %STKUNIT0-M:CP %JUMPSTART-5-BOOT_OFFER: DHCP tftp IP NIL sname NIL dns IP NIL router IP NIL.
13:23:48: %STKUNIT0-M:CP %JUMPSTART-5-BOOT_OFFER: DHCP image file NIL.
13:23:48: %STKUNIT0-M:CP %JUMPSTART-5-BOOT_OFFER: DHCP config file tftp://10.16.127.53/customer.conf.
13:23:49: %STKUNIT0-M:CP %JUMPSTART-5-BOOT_OFFER: stacking info NIL.
2. The system downloads the customer.conf configuration file from the file-server address if
config-scr-download
3. If the configuration download is successful, the following logs are displayed.
00:02:29: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DWNLD_CONFIG_SCRIPT_SUCCESS: The config file download is
successful.
00:02:30: %STKUNIT0-M:CP %JUMPSTART-5-DOWNLOAD_INFO: test123 config file successfully downloaded
00:02:31: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DOWNLOAD: The config file download is successful.
00:02:31: %STKUNIT0-M:CP %JUMPSTART-5-CFG_APPLY: The downloaded config from dhcp server is being applied
00:02:31: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading configuration file
00:02:31: %STKUNIT0-M:CP %JUMPSTART-5-PROCESS_COMPLETED: Autoconfig process is complete. The
configuration must be saved in order to use it after subsequent reloads
Reload with a DHCP Server Offer without a Configuration File
If a switch that is configured to reload in BMP mode reaches a DHCP server but cannot retrieve a
configuration file, the switch looks for a configuration file on the file server only if the
config-scr-download
1. The system boots up with the BMP application.
| Bare Metal Provisioning 3.0 (BMP 3.0)
250
is enabled.
command is enabled.