Sample Configurations - Dell Force10 Z9000 Configuration Manual

Task
Set the delay time for VRRP initialization on all
the interfaces in the system configured for
VRRP. This is the gap between system boot up
completion and VRRP enabling.

Sample Configurations

The following configurations are examples for enabling VRRP. These are not comprehensive directions.
They are intended to give you a some guidance with typical configurations.
You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to
support your own IP Addresses, Interfaces, Names, etc.
Figure 49-17
with that CLI configuration.
| Virtual Router Redundancy Protocol (VRRP)
962
is a sample configuration for enabling VRRP.
Command Syntax
vrrp delay reload seconds
Seconds range: 0-900
Default: 0
Figure 49-18
Command Mode
INTERFACE
illustrates the topology created