Configure Passive-Interface; Configure Stub Areas - Dell Force10 Z9000 Configuration Manual

Use the
no ipv6 router ospf process-id
Use the
clear ipv6 ospf process

Configure stub areas

Command Syntax
area stub
area-id
[ no-summary ]

Configure Passive-Interface

Use the following command to suppress the interface's participation on an OSPFv3 interface. This
command stops the router from sending updates on that interface.
Command Syntax
passive-interface
{type slot/port}
To enable both receiving and sending routing updates, enter the
When you configure a passive interface, the
interface" to indicate that hello packets are not transmitted on that interface.
command syntax in the CONFIGURATION mode to disable OSPF.
command syntax in the EXEC Privilege mode to reset the OSPFv3 process.
Command Mode
CONF-IPV6-ROUTER-OSPF
Command Mode
CONF-IPV6-ROUTER-OSPF
Usage
Configure the area as a stub area. Use the
no-summary keywords to prevent transmission in
to the area of summary ASBR LSAs.
Area ID is a number or IP address assigned when
creating the Area.
The Area ID can be represented as a number
between 0 – 65536 if a dotted decimal format is
assigned, rather than an IP address.
Usage
Specify whether some or all some of the interfaces will be
passive.
Interface identifies the specific interface that will be
passive.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(
e.g. passive-interface gi 2/1
For a port channel, enter the keyword port-channel
•
followed by a number from 1 to 255 for TeraScale and
ExaScale, 1 to 32 for EtherScale (
passive-interface po 100
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information (
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094 (
.
vlan 2222)
E-Series ExaScale platforms support 4094 VLANs with
FTOS version 8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.
no passive-interface interface
show ipv6 ospf interface
Open Shortest Path First (OSPFv2 and OSPFv3) | 655
e.g.
)
e.g. passive-interface ten 2/3
e.g. passive-interface
command adds the words "passive
).
).
command.