View Cam-Acl Settings - Dell Force10 Z9000 Configuration Manual

Reserved
FIB
ACL
Flow
EgACL
MicroCode Name
--More--
View a brief output of the command
The command
following example.
Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does not
reflect any changes until you save the running-configuration and reload the chassis.
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#

View CAM-ACL settings

show cam-acl
The
View the current cam-acl settings for the C-Series, S-Series and
component using the command
The default values for the
FTOS# show cam-acl
-- Chassis Cam ACL --
L2Acl
Ipv4Acl
Ipv6Acl
Ipv4Qos
L2Qos
L2PT
IpMacAcl
VmanQos
VmanDualQos
EcfmAcl
-- Line card 0 --
L2Acl
Ipv4Acl
Ipv6Acl
Ipv4Qos
| Content Addressable Memory (CAM)
268
: 8K entries
: 0 entries
: 0 entries
: 0 entries
: 0 entries
: Default
show cam-profile
show running-config cam-profile
command is supported on platforms
show cam-acl
show cam-acl
Current Settings(in block sizes)
: 2
: 2
: 2
: 2
: 2
: 1
: 2
: 0
: 0
: 0
Current Settings(in block sizes)
: 2
: 2
: 2
: 2
: 8K entries
: 0 entries
: 0 entries
: 0 entries
: 0 entries
: Default
summary
using the
shows the current profile and microcode as shown in the
c s
, as shown in as shown in the following examples.
command for C-Series and S-Series are:
option.
systems chassis and each