Autonomous System (As) Areas; Protocol Overview - Dell Force10 Z9000 Configuration Manual

Protocol Overview

Open Shortest Path First (OSPF) routing is a link-state routing protocol that calls for the sending of
Link-State Advertisements (LSAs)
Information on attached interfaces, metrics used, and other variables is included in OSPF LSAs. As OSPF
routers accumulate link-state information, they use the SPF algorithm (Shortest Path First algorithm) to
calculate the shortest path to each node.
OSPF routers initially exchange HELLO messages to set up adjacencies with neighbor routers. The
HELLO process is used to establish adjacencies between routers of the AS. It is not required that every
router within the Autonomous System areas establish adjacencies. If two routers on the same subnet agree
to become neighbors through the HELLO process, they begin to exchange network topology information
in the form of Link State Advertisements (LSAs).
OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis.
identified by Router ID (RID). In OSPFv2 neighbors on broadcast and NBMA links are identified
by their interface addresses, while neighbors on other types of links are identified by RID.
OSPFv3 removes this inconsistency, and all neighbors on all link types are identified by RID.
Note:
with both IPv4 and IPv6, you must run both OSPFv2 and OSPFv3.

Autonomous System (AS) Areas

OSPF operate in a type of hierarchy. The largest entity within the hierarchy is the autonomous system
(AS), which is a collection of networks under a common administration that share a common routing
strategy. OSPF is an intra-AS (interior gateway) routing protocol, although it is capable of receiving routes
from and sending routes to other ASs.
An AS can be divided into a number of areas, which are groups of contiguous networks and attached hosts.
Routers with multiple interfaces can participate in multiple areas. These routers, Area Border Routers
(ABRs), maintain separate databases for each area. Areas are a logical grouping of OSPF routers identified
by an integer or dotted-decimal number.
Areas allow you to further organize your routers within in the AS. One or more areas are required within
the AS. Areas are valuable in that they allow sub-networks to "hide" within the AS, thus minimizing the
size of the routing tables on all routers. An area within the AS may not see the details of another Area's
topology. AS areas are known by their area number or the router's IP address.
| Open Shortest Path First (OSPFv2 and OSPFv3)
620
OSPFv3 is not backward-compatible with OSPFv2; they can co-exist. To use OSPF
to all other routers within the same Autonomous System (AS)
All neighbors on all link types are
Areas.