Troubleshooting Packet Loss; Displaying Drop Counters - Dell Force10 Z9000 Configuration Manual

Figure 12-13. Single Queue Application for S50N with Default Packet Pointers
!
buffer-profile fp fsqueue-fp
buffer dedicated queue0 3 queue1 3 queue2 3 queue3 3 queue4 3 queue5 3 queue6 3 queue7 3
buffer dynamic 1256
!
buffer-profile fp fsqueue-hig
buffer dedicated queue0 3 queue1 3 queue2 3 queue3 3 queue4 3 queue5 3 queue6 3 queue7 3
buffer dynamic 1256
!
buffer fp-uplink stack-unit 0 port-set 0 buffer-policy fsqueue-hig
buffer fp-uplink stack-unit 0 port-set 1 buffer-policy fsqueue-hig
!
Interface range gi 0/1 - 48
buffer-policy fsqueue-fp
FTOS#sho run int gi 0/10
!
interface GigabitEthernet 0/10
no ip address
switchport
no shutdown
buffer-policy fsqueue-fp
FTPS#

Troubleshooting packet loss

The
show hardware stack-unit
• show hardware stack-unit cpu data-plane statistics
• show hardware stack-unit cpu party-bus statistics
• show hardware stack-unit 0-7 drops unit 0-5 port 0-49
•
show hardware stack-unit 0-7 unit 0-5 {counters | details | port-stats [detail] | register |
execute-shell-cmd | ipmc-replication | table-dump}
• show hardware {layer2| layer3} {e.g. acl |in acl} stack-unit 0-7 port-set 0-5
• show hardware layer3 qos stack-unit 0-7 port-set 0-5
• show hardware ipv6 {e.g.-acl |in-acl} stack-unit 0-7 port-set 0-5
• show hardware system-flow layer2 stack-unit 0-7 port-set 0-5 [counters]
• clear hardware stack-unit 0-7 counters
• clear hardware stack-unit 0-7 unit 0-5 counters
• clear hardware stack-unit 0-7 cpu data-plane statistics
• clear hardware stack-unit 0-7 cpu party-bus statistics

Displaying Drop Counters

The
show hardware stack-unit 0–7 drops [unit 0–5 [port 0–41]]
stack unit, port pipe, and port is experiencing internal drops, as shown in the following examples.
command is intended primarily to troubleshoot packet loss.
:
command assists in identifying which
Z-Series Debugging and Diagnostics | 305