Navigating Cli Modes - Dell Force10 Z9000 Configuration Manual

Figure 2-2. CLI Modes in FTOS
EXEC
EXEC Privilege
CONFIGURATION
ARCHIVE
AS-PATH ACL
INTERFACE
GIGABIT ETHERNET
10 GIGABIT ETHERNET
INTERFACE RANGE
LOOPBACK
MANAGEMENT ETHERNET
NULL
PORT-CHANNEL
SONET
VLAN
VRRP
IP
IPv6
IP COMMUNITY-LIST
IP ACCESS-LIST
STANDARD ACCESS-LIST
EXTENDED ACCESS-LIST
LINE
AUXILIARY
CONSOLE
VIRTUAL TERMINAL
MAC ACCESS-LIST
MONITOR SESSION
MULTIPLE SPANNING TREE
OPENFLOW
Per-VLAN SPANNING TREE
PREFIX-LIST
RAPID SPANNING TREE
REDIRECT
ROUTE-MAP
ROUTER BGP
ROUTER ISIS
ROUTER OSPF
ROUTER RIP
SPANNING TREE
TRACE-LIST

Navigating CLI Modes

The FTOS prompt changes to indicate the CLI mode.
information on how to access and exit this CLI mode. You must move linearly through the command
modes, with the exception of the
command moves you up one command mode level.
Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to
identify the mode and slot/port information. These are shown in
Table 2-1
end
command which takes you directly to EXEC Privilege mode; the
lists the CLI mode, its prompt, and
Table 2-1.
Configuration Fundamentals | 31
exit