Configure Storm Control From Configuration Mode - Dell Force10 Z9000 Configuration Manual

• The percentage of storm control is calculated based on the advertised rate of the line card, not by the
speed setting.

Configure storm control from CONFIGURATION mode

Configure storm control from CONFIGURATION mode using the command storm control. From
CONFIGURATION mode you can configure storm control for ingress and egress traffic.
Do not apply per-VLAN QoS on an interface that has storm-control enabled (either on an interface or
globally).
• On the E-Series, when broadcast storm-control is enabled on an interface or globally on the ingress and
DSCP marking for a DSCP value 1 is configured for the data traffic, the traffic goes to queue 1 instead
of queue 0. Similarly, if unicast storm-control is enabled on an interface or globally on the ingress, and
DSCP marking for a DSCP value 2 is configured for the data traffic, the traffic goes to queue 2 instead
of queue 0.
| Storm Control
874