Specify Local System Domain And A List Of Domains - Dell Force10 Z9000 Configuration Manual

Command Syntax
ip domain-lookup
ip name-server ip-address
[ip-address2 ... ip-address6]
To view current bindings, use the
Figure 20-5. show hosts Command Example
FTOS>show host
Default domain is force10networks.com
Name/address lookup uses domain service
Name servers are not set
Host
--------
ks
patch1
tomm-3
gxr
f00-3
FTOS>
To view the current configuration, use the

Specify local system domain and a list of domains

If you enter a partial domain, FTOS can search different domains to finish or fully qualify that partial
domain. A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. FTOS
searches the host table first to resolve the partial domain. The host table contains both statically configured
and dynamically learnt host and IP addresses. If FTOS cannot resolve the domain, it tries the domain name
assigned to the local system. If that does not resolve the partial domain, FTOS searches the list of domains
configured
To configure a domain name, use the following command in the CONFIGURATION mode:
Command Syntax
ip domain-name name
To configure a list of domain names, use the following command in the CONFIGURATION mode:
Command Mode Purpose
CONFIGURATION Enable dynamic resolution of host names.
CONFIGURATION Specify up to 6 name servers. The order you entered the
servers determines the order of their use.
show hosts
command.
Flags TTL Type
----- ---- ----
(perm, OK) - IP
(perm, OK) - IP
(perm, OK) - IP
(perm, OK) - IP
(perm, OK) - IP
show running-config resolve
Command Mode Purpose
CONFIGURATION Enter up to 63 characters to configure one domain name
for the E-Series.
Address
-------
2.2.2.2
192.68.69.2
192.68.99.2
192.71.18.2
192.71.23.1
command.
IPv4 Routing | 427