Boot Behavior; Example: Ef Line Card With Eg Chassis Profile (Card Problem) - Dell Force10 Z9000 Configuration Manual

The amount of space that you can distribute to the sub-partitions is equal to the amount of CAM space that
the selected CAM profile allocates to the Layer 2 ACL partition. FTOS requires that you specify the
amount of CAM space for all sub-partitions and that the sum of all sub-partitions is 100%. FTOS displays
the following message if the total allocated space is not correct:
% Error: Sum of all regions does not total to 100%.

Boot Behavior

The profile and microcode loaded on the primary RPM determines the profile and microcode that is
required on all other chassis components and is called the "chassis profile." A profile mismatch condition
exists if either the CAM profile or the microcode does not match. The following points describe line card
boot behavior when the line card profile does not match the chassis profile.
• A microcode mismatch constitutes a profile mismatch.
• When the line card profile and chassis profile are of the same type (single-CAM or dual-CAM), but
their CAM profiles do not match, the line card must load a new profile and therefore takes longer to
come online.
• If you insert a single-CAM line card into a chassis with a dual-CAM profile, the system displays
Message 1. The line card boots with the default (single-CAM) profile and remains in a problem state
as shown in the following command output example. The line card cannot forward traffic in a problem
state.
• If you insert a dual-CAM line card into a chassis with a single-CAM profile, the line card boots with a
matching profile, but operates with a lower capability.
Message 1 EF Line Card with EG Chassis Profile Error
# Before reload:
01:09:56: %RPM0-P:CP %CHMGR-4-EG_PROFILE_WARN: If EG CAM profile is selected, non-EG
cards will be in problem state after reload
# After reload:
00:04:46: %RPM0-P:CP %CHMGR-3-PROFILE_MISMATCH: Mismatch: line card 1 has mismatch CAM
profile or microcode
Message 2 EH Line Card with EG Chassis Profile Error
# Before reload:
01:09:56: %RPM0-P:CP %CHMGR-4-EH_PROFILE_WARN: If EH CAM profile is selected, non-EJ
cards will be in problem state after reload
# After reload:
00:04:46: %RPM0-P:CP %CHMGR-3-PROFILE_MISMATCH: Mismatch: line card 1 has mismatch CAM
profile or microcode
Example: EF Line Card with EG Chassis Profile (Card
Problem)
R1#show linecard 1 brief
Content Addressable Memory (CAM) | 263