Rgbhv+Stereo To Catpro Boards Specifications - AMX Modula Instruction Manual

RGBHV+Stereo to CatPro Boards Specifications

Applies to RGBHV+Stereo to CatPro input board FG1034-487 and output board FG1034-490 when
used in conjunction with CatPro RGBHV+Stereo TX and RX Modules using Cat5e cable (for module
specifications, see page 72).
Also applies to these boards when contained in pre-engineered systems using CatPro TX and RX
Modules.
Video Specifications
Parameter
Signal Types
Maximum Resolution
RGB In
Signal Level Range (max.)
RGB Out
Signal Level Range (max.)
RGB In
Skew Adjustment
RGB Out
Skew Adjustment
RGB In/Out Impedance
RGB Signal to Noise Ratio
RGB Crosstalk
RGB Return Loss
Sync In Impedance
Sync In/Out Polarity
Sync Out Signal Levels
Supported Twisted-Pair
Cable Types***
RGBHV+Stereo
Connector Options
* Signals displayed using a resolution of 1600x1200 at 60 Hz may exhibit slightly visible background noise in
certain circumstances (particularly with LCD monitors).
** Overall transmission distance including input and output cannot exceed 1,000 ft. (305 m) from source to
destination.
*** All measurements were taken using Cat5e cable.
Modula Instruction Manual
Conditions
Terminated, user adjustable gain and peak
using CatPro Wizard
Terminated, user adjustable gain and peak
using CatPro RX Module
User adjustable using CatPro Wizard
User adjustable using CatPro RX Module
f = 30 MHz
f = 5 MHz
f = 5 MHz
Output follows input polarity
Unterminated
RGBHV+Stereo to CatPro Boards with TXs & RXs
Value
RGBHV and stereo audio
1600x1200* (4:3) and
1920x1080p (16:9)
@ 60 Hz up to 1000 ft.** (305 m)
+0.75 V to -0.3 V typical
+0.75 V to -0.3 V typical
0 to 62 ns in 2 ns increments
on R, G, and B channels
0 to 62 ns in 2 ns increments
on R, G, and B channels
75 ohms
>50 dB
<-35 dB
<-50 dB
<-35 dB
510 ohms
Active high or low
Low = 0 V
High = +5 V
Cat5, Cat5e, Cat6, Cat6e, STP
(skew-free cable is not
recommended)
Female RJ-45
71