AMX Modula Instruction Manual page 91

12. Turn the Adjust knob clockwise to increase volume or counterclockwise to decrease volume.
13. Press the Adjust knob.
The LED turns off, and the module saves all of the settings.
Additional fine-tuning with the potentiometers may be necessary. If undesirable display conditions
persist, see Troubleshooting on page 92.
Tip: For optimal results on flat panel LCDs, use page 2 of the .pdf test image and press the auto-
adjust button on the panel after using the potentiometers and the Adjust knob.
To abort the adjustment procedure at any time:
1. Hold the Adjust knob down until the LED turns amber, then release the knob.
The LED blinks 3 times and the RX Module reverts to its previous settings.
Cycling power on the CatPro RX Module during the adjustment procedure will have the same effect.
Individual settings are not stored in memory until all adjustments (Steps 1 through 13) have been made.
LED Blinks Red and Green
If the LED alternately blinks red and green, a configuration failure has occurred.
Modula Instruction Manual
If the blinking happens when the Adjust knob is pressed to save (Step 13), the system failed to
save the settings. Any adjustments just made are still in effect, but will be lost the next time
power is cycled. Press the Adjust knob; repeat (cycle the colors) until the LED turns off.
If the blinking happens when power is cycled, the system could not find valid settings and
reverted to the factory defined default settings. Complete Steps 5 through 13 again.
RGBHV+Stereo to CatPro Boards with TXs & RXs
85