AMX Modula Instruction Manual page 86

RGBHV+Stereo to CatPro Boards with TXs & RXs
page 152
Routing Path C
In Routing Path C (FIG. 44), the signal from a source device is sent to a CatPro TX Module, which
passes the RGBHV and stereo audio signals to the CatPro input board. The signals are then routed to the
CatPro output board and on to the CatPro RX Module, which sends the signals to the destination device.
The total length of the cables between the two modules cannot exceed 1,000 ft. (305 m). The video
display is adjusted using the Wizard / RX Hardware Method (see page 89).
Source
FIG. 44
80
CatPro TX Module CatPro Input Board
Routing Path C
CatPro Output Board
Total length for Cat5 Cables A and B
cannot exceed 1000 ft. (305 m).
CatPro RX Module Destination
Modula Instruction Manual