Attaching Cables - AMX Modula Instruction Manual

Specifications Table 2
Applies to wideband video input and output boards listed in Applicability Table 2 (page 52).
Also applies to these wideband video boards when contained in pre-engineered systems.
Specifications Table 2
Frequency Response
Crosstalk
Signal to Noise Ratio
Input Level
Input Impedance
Return Loss – CatPro RGBHV/HD-15 enclosures only
Output Level
Output Impedance
Connector Type
AMX reserves the right to modify its products and their specifications without notice.

Attaching Cables

When attaching wideband input and output cables, refer to the sheet labeled "AutoPatch Modula Connector
Guide" that ships with the system. The sheet shows you where to attach each cable on the rear of each
enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as indicated
on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1 of 3") on a
label located on the left side (near the power receptacle).
To connect wideband video inputs and outputs:
1.
Fasten the cables onto the input and output BNC connectors (FIG. 27).
FIG. 27
Fasten cable onto input or output BNC connector
Make sure the video cable is connected to the correct BNC connector on the correct enclosure. Wideband
video boards look similar to standard, HV sync, HD-SDI digital, SD-SDI digital, and vertical interval sync
boards, but the "Connector Guide" identifies them.
Modula Instruction Manual
Parameter Conditions
1 to All ±3 dB to 300 MHz or better
±1.5 dB to 200 MHz or better
±1 dB to 60 MHz or better
f = 5 MHz <-60 dB
f = 150 MHz <-30 dB
Vin = 0.7 V, 100 IRE >60 dB
±1.75 V
75 ohms
<-45 dB
±1.75 V
75 ohms
BNC
Wideband Boards
Value
53