Attaching Cables And Wires - AMX Modula Instruction Manual

RGBHV+Stereo to CatPro Boards with TXs & RXs
CatPro RGBHV+Stereo RX and TX Modules Specifications (continued)
Specifications – RX Module (FG1010-48-01)
Parameter
RGB Out (at 1000 ft.)
Signal Level Range:
Impedance:
Signal to Noise Ratio:
Skew Adjustment:
Sync Output
Signal Levels:
Polarity:
Audio Out (at 1000 ft.)
Signal Level (max.):
Volume Control Range:
Frequency Response:
THD+Noise:
Signal to Noise Ratio:
Impedance:
Connector Options
RGBHV+Stereo Input:
RGBHV Out:
Stereo Audio Out:
AMX reserves the right to modify its products and their specifications without notice.

Attaching Cables and Wires

Important: Before attaching cables and wires – For important information, see CatPro system
equipment requirements on page 77 and see setting up a CatPro system on page 78.
When attaching input and output cables and wires, refer to the sheet labeled "AutoPatch Modula
Connector Guide" that ships with the system. The sheet shows you where to attach the cables and wires
on each enclosure. Follow the sheet exactly; the system was programmed to operate only as indicated on
the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1 of 3") on a
label located on the left side (near the power receptacle).
Important: To guarantee 1,000 ft. (305 m) skew compensation, the inter-pair skew must be rated at
≤20 ns /100 m. The cables should be tested for skew which will determine whether the run has less
than 62 ns skew and is within 1,000 feet (305 m).
CatPro Supported Twisted-Pair Cable Types
Note: Skew-free cable is not recommended for use with AMX AutoPatch equipment.
74
Terminated, user adjustable with gain and peak
User adjustable
Unterminated
Follows input polarity
User adjustable
f = 20 Hz to 20 kHz
f = 1 kHz, Vin = 10 dBu to +4 dBu
f = 20 Hz to 20 kHz, Vin = +4 dBu
Cat5
Cat5e
Cat6
Cat6e
STP (Shielded Twisted Pair)
Conditions Value
+0.75 V to -0.3 V typical
75 ohms
>50 dB
0 to 62 ns, in 2 ns increments
on R, G, and B channels
Low = 0 V, High = +5 V
Active high or low
+8 dBu (unity gain)
Mute to +6 dB
<±0.2 dB
<0.04%
>105 dB
<5 ohm
1 Female RJ-45
1 Female HD-15
1 Pluggable 3.5 mm terminal
block
Modula Instruction Manual