AMX Modula Instruction Manual page 168

Appendix B – Advanced Configuration: Modifying Virtual Matrices
The information in the dialog boxes for the following section is based on the following scenario. An
enclosure configured for 16x16 standard video is reconfigured to switch 8x8 Y/c by creating a new
VM 2 that switches 8 channels of "Y" and 8 channels of "c" using the previous "composite" channels.
Note: For additional information on creating virtual matrices, see the XNConnect Help file. To access
the Help file topic for an open dialog box, press F1.
To create a new virtual matrix:
1. From the Virtual Matrix menu, select Add Virtual Matrix.
The Assign Virtual Matrix Signals dialog box opens.
Select the signal
2.
Under the Supported System Signals list (use either tab), select the signals for the new VM
(to select multiple signals, hold the down the Control key) and click Assign Signal.
3.
Under Virtual Matrix Info, enter a number and a unique name. Click OK.
The Assign Signals to Matrices dialog box opens.
Select signal
4.
From the Available Signals box, select the signal.
5. If applicable – For a multiple-enclosure system, from the Enclosure drop down list, select the
correct enclosure.
6. From the Physical Matrix drop down list, select the matrix (see "The Physical Matrix" on
page 161).
7. Click Assign Matrix.
8. Repeat Steps 4 through 7 for additional signals.
162
Click OK
Click OK
Enter a number and name
Click Assign Signal
Check the signals to be
assigned
Check the settings
Select enclosure
Select the physical matrix
Click Assign Matrix
Modula Instruction Manual