AMX Modula Instruction Manual page 85

Routing Path A
In Routing Path A (FIG. 42), the RGBHV and stereo signals from a source device are sent to an
RGBHV/HD-15 input board and a CatPro-compatible stereo audio input board, which route the signals
to a CatPro output board. The signal is then passed to the CatPro RX Module, which sends the signals to
the destination device. The cable between the Modula and the RX Module cannot exceed 1,000 ft.
(305 m). The video display is adjusted using the RX Hardware Method (see page 82).
Source
FIG. 42
Routing Path A
Routing Path B
In Routing Path B (FIG. 43), the RGBHV and stereo signals from a source device are sent to a CatPro
TX Module, which passes the signals to the CatPro input board. The signal is then routed through the
RGBHV/HD-15 and CatPro-compatible stereo output boards to the destination device. The cable
between the CatPro TX Module and the Modula cannot exceed 1,000 ft. (305 m). The video display is
adjusted using the CatPro Wizard on the Control PC (see page 86).
Source
FIG. 43
Routing Path B
Modula Instruction Manual
RGBHV/HD-15 Input Board CatPro Output Board
CatPro TX Module CatPro Input Board
RGBHV+Stereo to CatPro Boards with TXs & RXs
CatPro RX Module
RGBHV/HD-15 Output Board
Destination
Destination
79