AMX Modula Instruction Manual page 94

RGBHV+Stereo to CatPro Boards with TXs & RXs
8.
Select Red Skew and move the slider until the red color bars align as closely as possible with the
green color bars
9.
Select Blue Skew and move the slider until the blue color bars align with the red and green ones. (If
necessary, reselect the icons and adjust further.)
FIG. 55
Test image adjusted for skew
10. If necessary, make final adjustments for the gain and peak.
11. Repeat Steps 2 through 10 for all CatPro inputs using the appropriate sources and their
TX Modules (for applying the settings to multiple sources, see below).
12. From the Options menu, select Save to System (to restore the settings upon power up).
The Save to System dialog box opens.
13. Click OK.
14. From the File menu, select Save As to save a backup file to the PC.
15. Enter a file name, and click OK.
Tip: For optimal results on flat panel LCDs, use page 2 of the .pdf test image file and press the auto-
adjust button on the panel after using the Wizard.
If additional source devices of the same type are connected to the same type of destination devices with
similar cable runs, the settings for the file saved in Step 14 can be applied to those sources.
To apply settings to multiple sources:
1. From the Options menu, select Enable Multiple Selections.
2.
Highlight the source whose settings need to be duplicated.
FIG. 56
Select the sources
3.
Click the check boxes for all sources that require the same settings.
4. From the Options menu, open the Copy to Selected submenu and select Current Profile.
The settings are applied to all sources that were selected in Step 3.
If undesirable display conditions persist after using the adjustment procedure, see Troubleshooting on
page 92.
88
Source with settings to be duplicated
Sources requiring the duplicated settings
Modula Instruction Manual