Ventilation; Installing Input And Output Boards - AMX DUX-12F User Manual

5.2 Ventilation

Brackets attach at the side
ALWAYS ensure the Matrix is adequately ventilated. Do not block any
toward the front of the Matrix
ventilation openings. Sufficient airflow must be achieved (by convention or
force-air cooling) to satisfy the ventilation requirements of all the equipment
installed within the rack.
NOTE: The maximum operating temperature of the Matrix is 45°C
(113°F).
NOTE: The Matrix shall not be installed in enclosed spaces. It is
recommended that you leave 1U space above the Matrix when you
install it in a rack.

5.3 Installing Input and Output Boards

With a DUX-12F, you may build up a switching system of up to 11 (inputs) x
1 (output) or 1 (input) x 11 (outputs) by a combined use of the DUX Series
HDMI / HDBaseT input and output boards. (For more information about these
HDMI and HDBaseT input and output boards, please refer to their respective
technical document.)
The basic rule below should be followed while installing the DUX Series HDMI
/ HDBaseT input and output boards to the DUX-12F:
If the quantity of input boards (including HDMI & HDBT input boards)
is M, the quantity of output boards (including HDMI & HDBT output
boards) is N (M≤11, N≤11, M+N≤12), then
1) Insert all the input boards to slot 1 to M of the Matrix;
2) Insert all the output boards to slot M+1 to M+N of the Matrix.
12
1U open space
1U open space
Equipment Rack
DUX-12F
USER MANUAL