Attaching Cables - AMX Modula Instruction Manual

Standard Video Boards

Attaching Cables

Important: If using Cat5 compatible standard video boards – for information on installation and
system setup, first see "Cat5 Video and Audio Boards with TXs & RXs" starting on page 123.
When attaching standard video input and output cables, refer to the sheet labeled "AutoPatch Modula
Connector Guide" that ships with the system. The sheet shows you where to attach each cable and each
wire on the rear of each enclosure. Follow the sheet exactly; the system was programmed at the factory
to operate only as indicated on the sheet.
Attaching Video Cables
To connect video inputs and outputs:
1.
Fasten the cables onto the input and output BNC connectors (FIG. 25).
FIG. 25
Fasten cable onto input or output BNC connector
Make sure the video cable is connected to the correct BNC connector on the correct enclosure. Standard
video boards look similar to wideband, HV sync, HD-SDI digital, SD-SDI digital, and vertical interval
sync boards, but the "Connector Guide" identifies them.
50 Modula Instruction Manual