Table of Contents
Advertisement
Epica DGX 32 SC Optical Boards
Specifications Epica DGX 32 SC Optical Boards
Applies to input board FG1056-500 and output board FG1056-510.
Compatible AMX AutoPatch DGX Fiber modules:
Note: Either Transmitter (TX) module can be used in conjunction with either Receiver (RX) module.
Epica DGX 32 SC Optical Specifications
Parameter
Compatible AMX AutoPatch Fiber Products DGX HD-15 TX and RX, DGX DVI TX and RX,
Signal Types over Fiber
Resolution Support
Interlaced Resolution Support
Audio Support
Serial Data Support
Fiber Cable Type
Fiber Cable Length
Optical Budget
Power Output of Laser Radiation (max.)
Safety Certifications
Fiber Connector
* 96 kHz audio is only available when the source video resolution is 800x600 @ 60 Hz (40 MHz pixel clock) or
greater. Otherwise 48 kHz is the maximum.
** 3000 ft. cable requires 50/125 μm OM2 class low loss fiber cable.
***480i and 576i are only available when being transmitted from a DGX HD-15 TX as a Y-Pb-Pr signal.
Important: These boards are compatible only with other AMX AutoPatch products that support
the DGX single fiber technology. They are not compatible with third-party optical distribution
amplifiers or multimode to single-mode converters.
AMX reserves the right to modify its products and their specifications without notice.
46
FG1010-200-01 – AVB-TX-DGX-HD15-SC Fiber
FG1010-210-01 – AVB-TX-DGX-DVI-SC Fiber
FG1010-400-01 – AVB-RX-DGX-SC Fiber-HD15
FG1010-410-01 – AVB-RX-DGX-SC Fiber-DVI
Value
other AMX AutoPatch DGX SC Fiber signal management
products
Video, audio, serial data
Video signal must be present to pass audio and serial data
640x480 @ 60 Hz up to 1920x1200 @ 60 Hz
1080i 60, 59.94, 50 (fields per second)
576i 100, 50 (fields per second)***
480i 60 (fields per second)***
Analog stereo or S/PDIF (S/PDIF up to 96 kHz sample rate*)
Unidirectional RS-232, up to 115.2 k baud
Multimode Simplex (with SC termination)
50/125 μm (preferred) or 62.5/125 μm
Up to 3000 ft. (914.4 m) in with 50 μm cable**
Up to 3000 ft. (914.4 m) out with 50 μm cable**
Up to 1500 ft. (457.2 m) in with 62.5 μm cable
Up to 1500 ft. (457.2 m) out with 62.5 μm cable
9.75 dBm (typical) between DGX TX and input board
9.75 dBm (typical) between output board and DGX RX
Optical Modulation Amplitude (OMA) Output: -6.25 dBm (typical)
Optical Modulation Amplitude (OMA) Input Sensitivity: -16.0 dBm
(typical)
4.08 mW (DGX 32 SC Optical Output Board)
Class 1 Laser Product (Class 3R Laser Product when fiber is
disconnected from the unit) IEC 60825-1, 2001
(DGX 32 SC Optical Output Board)
SC optical
Epica DGX 32 Instruction Manual
Advertisement
Table of Contents
