Epica Dg Rgbhv/Hd-15 Boards - AMX Epica DG Instruction Manual

Epica DG RGBHV/HD-15 Boards

Applicability Notice
This chapter pertains to the following Epica DG (Digital Generation) RGBHV/HD-15 boards:
FIG. 26 Epica DG RGBHV/HD-15 boards
Epica DG enclosures are built to hold up to eighteen DG RGBHV/HD-15 boards with sixteen HD-15
connectors each. Each enclosure holds a maximum of nine input and nine output boards, accommodating
connector configurations up to a maximum of 144x144, as well as subsets (e.g., 128x64 or 80x112).
DG RGBHV/HD-15 input boards route signals to any other type of Epica DG output boards, and
DG RGBHV/HD-15 output boards can accept signals from any other type of Epica DG input boards.
When routing signals between different board types, the Epica DG automatically converts the signal
format (analog to digital or digital to analog) to match the output board.
Board configuration software is provided to adjust the source signal for optimal display (page 53). EDID
Programmer software is also included for programming the input boards if necessary
(see "Appendix A – EDID Programmer" on page 61). Both programs are on the AMX AutoPatch CD
(also available at www.amx.com).
Epica DG Instruction Manual
FG1055-422 Input board
FG1055-425 Output board
Epica DG RGBHV/HD-15 Boards
49