Attaching Wires - AMX Modula Instruction Manual

Attaching Wires

Important:
When attaching stereo audio input and output wires, refer to the sheet labeled "AutoPatch Modula
Connector Guide" that ships with the system. The sheet shows you where to attach the wires on the rear of
each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1
of 3") on a label located on the left side (near the power receptacle).
Wiring Sources and Destinations
Source and destination devices will require either balanced (differential) or unbalanced (single-ended)
connections. The diagram in FIG. 62 illustrates the options for wiring connections between the sources and
the input connectors and between the output connectors and the destinations. More than one of these options
can be used in the same system. FIG. 63 shows details for balanced and unbalanced wiring.
FIG. 62
Options for source-to-Modula-to destination 5-term wiring
Modula Instruction Manual
If using Cat5 compatible stereo audio boards – for information on installation and system
setup, first see "Cat5 Video and Audio Boards with TXs & RXs" starting on page 123.
If using CatPro-compatible stereo audio boards – for information on installation and system
setup, first see "RGBHV+Stereo to CatPro Boards with TX & RX Modules" starting on
page 69.
Stereo Audio Boards
99