Serial Control Device Startup - AMX Modula Instruction Manual

Installation and Setup

Serial Control Device Startup

If you have not already done so, attach the serial control device to the serial port on the enclosure
(see page 31) and open the control program.
AMX Control Devices
Modula Distribution Matrices are compatible with a number of AMX control devices. For control
programming information, see the instruction manual for the specific interface.
APControl 3.0
If you are using APControl 3.0, install and open the program. Follow the directions in the setup wizard
to discover the system's configuration. From the Launchbar menu, select Views / CrossBar and click on
the crosspoints to execute switches.
APWeb
For startup information, see the APWeb Server Module documentation.
HyperTerminal
When power is applied to the enclosure, HyperTerminal displays a short splash screen followed by
"Ready" (FIG. 23). The system is ready for a test switch (see page 41).
AutoPatch Modula signal router
Host software: v3.1.0
Hardware driver: v0.0.11 R
Built on Jan 16 2008 12:31:53
XNet address: 0x0003.
Ready
FIG. 23
Power-up splash screen in HyperTerminal
FIG. 23 shows an example of a short splash screen (your system's splash screen may differ). The short
splash screen provides the following information:
To see advanced system information, enter ~scr! to view a long splash screen.
Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.
40
Host software – version of the initial operating system (IOS)
Hardware driver – the firmware version
Built – date the software was built
XNet address – enclosure's XNNet identification number
Modula Instruction Manual