Rgbhv+Stereo To Catpro Boards I/O Boards Specifications - AMX Optima Instruction Manual

RGBHV+Stereo to CatPro I/O Boards (with RX Modules)

RGBHV+Stereo to CatPro Boards I/O Boards Specifications

RGBHV+Stereo to CatPro board specifications were measured in conjunction with CatPro
RGBHV+Stereo RX Modules using Cat5e cable (for module specifications, see page 98).
Applies to I/O boards: FG1046-575, FG1046-581.
These boards come in a number of pre-engineered systems or can be ordered individually for custom
systems.
Specifications
Maximum Resolution
RGB Crosstalk
RGB Signal to Noise Ratio (SNR) Vin = 0.7 V, 100 IRE
RGB Input Signal Level Range
(max.)
RGB Return Loss
RGB Input Impedance
Sync Input Impedance
Sync Input Polarity
Audio Frequency Response
Audio THD+Noise
Audio Crosstalk
Audio Signal to Noise Ratio
(SNR)
Audio Input Level (max.)
Audio Input Impedance
RGB Output Signal Level Range
(max.)
RGB Output Skew Adjustment
RGB Output Impedance
Sync Output Signal Level
Sync Output Polarity
Audio Output Level (max.)
Audio Output Impedance
Audio Output Volume
Adjustment Range
Signal Types
Connector Types
Supported Twisted Pair Cable
Types
* Signals displayed using a resolution of 1600x1200 at 60 Hz may exhibit slightly visible background noise in
certain circumstances (particularly with LCD monitors).
Note: Skew-free cable is not recommended for use with AMX equipment.
96
Parameter
@ 60 Hz up to 1000 ft. (305 m) 1600x1200* (4:3)
f = 5 MHz
f = 30 MHz
f = 5 MHz
Active high or low
20 Hz to 20 kHz
1 kHz, -10 dBu to +4 dBu
1 kHz, Vin = +4 dBu
20 Hz to 20 kHz, Vin = +8 dBu
Active high or low
Conditions
1920x1080p (16:9)
<-60 dB
<-45 dB
>50 dB
+0.75 V to -0.3 V typical
(terminated)
<-55 dB
75 ohms
2.2 kohms
Output follows input polarity
<±0.3 dB
<0.04%
<-95 dB
>85 dB
+8 dBu
18 kohms
+0.75 V to -0.3 V typical (terminated,
user adjustable with gain and peak using
CatPro RX)
0 to 62 ns, in 2 ns increments on R, G,
and B channels (user adjustable using
CatPro RX)
75 ohms
Low = 0 V, High = +5 V (unterminated)
Output follows input polarity
+8 dBu
<5 ohm
Mute to +6 dB (user adjustable at
CatPro RX)
Input: RGBHV+Stereo Audio (balanced
or unbalanced)
Output: CatPro RGBHV+Stereo Audio
(unbalanced)
Input: HD-15 and pluggable 5-position
terminal block
Output: Female RJ-45
Category cable 5, 5e, 6, 6e, UTP, and STP.
All measurements taken using Cat5e.
Value
Optima Instruction Manual